Informational message: The command is not valid for transmission on the network. The following conditions are detected by the CEC node during hypervisor command processing. The command is rejected directly by the CEC node for the following reasons:

• The command from the hypervisor was not defined.
• The RPF or RPN command from the hypervisor specified R = 0. (Programming cannot power the system off via this mechanism).
• The LSP subset command (0x'1X') was not addressed to a specific node.
• The APX command was not addressed to RRRR=01-3FFF, UU=0.
• A QSX command was not addressed to RRRR=0 , UU=D.

The information found in this error log entry may be used by product engineering to debug system power control network (SPCN) failures.